Boeing 747-200

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-100, -100B, -100B SUD, -200B, -200C, - 200F, -300, -400, -400D, -400F, 747SP, and 747SR series airplanes. This AD was prompted by reports of corrosion damage found on a certain satellite communications (SATCOM) high gain antenna adapter plate. This AD requires repetitive detailed inspections (DETs) of the SATCOM high gain antenna adapter plate for corrosion and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-8 and -8F series airplanes and Model 777- 200, -200LR, -300, -300ER, and 777F series airplanes. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G Lower C-Band) while operating in Canadian airspace, and the determination that this interference may affect multiple other airplane systems using radio altimeter data, including the pitch control laws, including those that provide tail strike protection, regardless of the approach type or weather. This AD requires revising the existing airplane flight manual (AFM) to incorporate limitations prohibiting certain operations requiring radio altimeter data when operating in Canadian airspace. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-100, -100B, -100B SUD, -200B, -200C, - 200F, -300, -400, -400D, and -400F series airplanes. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G Lower C-Band) while operating in Canadian airspace, and a determination that during takeoff, approach, landings, and go-arounds, as a result of this interference, certain airplane systems may not properly function, resulting in increased flightcrew workload while on approach with the flight director, autothrottle, or autopilot engaged, which could result in reduced ability of the flightcrew to maintain safe flight and landing of the airplane. This AD requires revising the existing airplane flight manual (AFM) to incorporate limitations prohibiting certain operations requiring radio altimeter data when operating in Canadian airspace. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747 airplanes. This AD was prompted by a report that a right-hand outboard elevator was received and installed without balance weights. This AD requires doing a maintenance records check to determine if certain outboard elevators are installed or an inspection to determine if outboard elevators have balance weights, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 747-400, 747-400F, 747-8F, and 747-8 series airplanes. This AD was prompted by a report that, during potable water servicing, there were multiple engine indicating and crew alerting system messages. The cause was the separation of a fitting and steel water supply tube above an electronics equipment cooling air filter, behind the forward cargo compartment left sidewall. This AD requires, depending on configuration, installing at certain locations: conduits on exposed potable water supply lines, envelope assemblies over all exposed potable water line fittings and exposed potable water supply lines, a slitted spray shield, a two-piece deflector shield around the equipment cooling system (ECS) air inlet, and/or a shroud on exposed potable water supply lines. The FAA is issuing this AD to address the unsafe condition on these products.