CORROSION

The FAA is superseding Airworthiness Directive (AD) 2020-06- 13, which applied to certain Airbus Helicopters Model AS332C, AS332C1, AS332L, and AS332L1 helicopters. AD 2020-06-13 required determining the accumulated hours time-in-service (TIS) of certain part-numbered main gearbox (MGB) suspension bar rear attachment fittings (fittings) and bolts and established reduced life limits. Since the FAA issued AD 2020-06-13, it was determined that modifying the MGB suspension bar fittings link and installing improved MGB suspension bar fitting bolts was necessary. This AD requires modifying the MGB suspension bar link, installing newly-designed bolts, and prohibits installing certain parts. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain MD Helicopters, LLC, Model 369 (Army YOH-6A), 369A (Army OH- 6A), 369D, 369E, 369F, 369FF, 369H, 369HE, 369HM, 369HS, 500N, and 600N helicopters. This AD was prompted by multiple reports of cracked tail rotor (T/R) pedal support brackets. This AD requires repetitively inspecting certain part-numbered T/R pedal support brackets and depending on the results, replacing the T/R pedal support bracket or refinishing any exposed areas. This AD also prohibits installing certain part-numbered T/R pedal support brackets. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2024-19-11 for all Robinson Helicopter Company Model R44 and R44 II helicopters. AD 2024-19-11 required visually inspecting a certain flex plate assembly (flex plate) and certain clutch shaft forward yokes (yokes), including each flex plate bolt, and depending on the results, taking corrective actions. AD 2024-19-11 also required removing certain yokes from service within a specified threshold, or as an alternative, performing in-depth inspections. Since the FAA issued AD 2024-19-11, it has been determined that clarifications regarding the alternative inspections are necessary. This AD requires the actions of AD 2024-19- 11 and clarifies that the alternative inspections are repetitive and adds a particular paint remover option to use when performing those alternative inspections. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Bell Textron Inc. (Bell) Model 204B, 205A, 205A-1, 205B, and 210 helicopters. This AD was prompted by an accident and incidents involving failure of the tail boom attachment structure. This AD requires inspecting the tail boom assembly hardware, replacing tail boom attachment hardware, greasing the bolt shanks, and inspecting torque. This AD also prohibits installing steel alloy nuts on any helicopter. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Robinson Helicopter Company Model R44 and R44 II helicopters. This AD was prompted by reports of a fractured clutch shaft forward yoke (yoke) on the main rotor (M/R) drive due to fatigue cracking. This AD requires visually inspecting a certain part-numbered flex plate assembly (flex plate) and certain part-numbered yokes, including each flex plate bolt, and depending on the inspection results, removing an affected part from service and replacing an affected part with an airworthy part. This AD also requires removing a certain part-numbered yoke from service after accumulating a certain number of hours time-in-service (TIS) or a certain number of years, or as an alternative to removing the part from service, performing a 10x or higher power magnification visual inspection and, if needed, a magnetic particle inspection. The FAA is issuing this AD to address the unsafe condition on these products.