Boeing 737-100

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-, -200, -200C, -300, -400, -500, -600, - 700, -700C, -800, -900, and -900ER series airplanes, except for Model 737-200 and -200C series airplanes equipped with a certain flight control system. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G Lower C-Band) while operating in Canadian airspace, and the determination that, during approach, landings, and go-arounds, as a result of this interference, certain airplane systems may not properly function, resulting in increased flightcrew workload while on approach with the flight director, autothrottle, or autopilot engaged, which could result in reduced ability of the flightcrew to maintain safe flight and landing of the airplane. This AD requires revising the existing airplane flight manual (AFM) to incorporate limitations prohibiting certain operations requiring radio altimeter data when operating in Canadian airspace. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. This AD was prompted by a report of cracks found in the fuselage skin underneath the aft drain mast. This AD requires repetitive inspections of the fuselage skin and structure common to the aft drain mast for any crack or corrosion and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2023-09- 04, which applied to certain The Boeing Company Model 737-600, -700, - 700C, -800, -900, and -900ER series airplanes, and certain Model 737-8 and -9 airplanes. AD 2023-09-04 required inspecting all escape slide assemblies to identify affected parts and replacing affected escape slide assemblies with different assemblies. This AD was prompted by the determination that additional airplanes might be affected by the unsafe condition. This AD retains the requirements of AD 2023-09-04 and requires those actions for additional airplanes, including Model 737- 8200 airplanes. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-700, -800, -900, and -900ER series airplanes. This AD was prompted by a report of a runway excursion caused by loss of braking. An inspection found that the right main landing gear (MLG) hydraulic hoses for the brakes were incorrectly installed at the flow limiters, and the left MLG wheel speed transducer wires were also interchanged. This AD requires a general visual inspection (GVI) of the left and right MLG brake hydraulic hoses for any crossed installation, antiskid valve and transducer operational tests, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This AD was prompted by a report of improper grinding of the inner diameter of the main landing gear (MLG) outer cylinders, resulting in possible heat damage to the outer cylinders. This AD requires a records check or inspection to determine if an affected outer cylinder is installed and replacing all affected outer cylinders. The FAA is issuing this AD to address the unsafe condition on these products.